Modify ONLY the PCB footprint for this Generic Inductor component so it matches the Coilcraft MSS1260T footprint used by MSS1260T-393MLD.

Do NOT modify the schematic symbol, electrical connectivity, terminal mapping, manufacturer, MPN, or any other component properties.

Set the existing pads exactly as follows:

P1:
Position X = 0.00 mm
Position Y = +4.25 mm
Size X = 5.50 mm
Size Y = 4.00 mm
Pad Type = Surface Mount
Pad Shape = Rectangle
Layer = Top
Rotation = 0 degrees

P2:
Position X = 0.00 mm
Position Y = -4.25 mm
Size X = 5.50 mm
Size Y = 4.00 mm
Pad Type = Surface Mount
Pad Shape = Rectangle
Layer = Top
Rotation = 0 degrees

Requirements:
- Keep P1 and P2 as the two existing electrical terminals.
- P1 and P2 must remain electrically distinct.
- Pad center-to-center spacing must be exactly 8.50 mm.
- Do NOT add vias.
- Do NOT add through-hole pads.
- Do NOT add copper pours.
- Do NOT add traces.
- Do NOT add additional electrical pads.
- Do NOT estimate or invent dimensions.
- Do NOT change anything outside this footprint.

After making the changes, verify and report:
1. P1 dimensions and position.
2. P2 dimensions and position.
3. Center-to-center pad spacing.
4. That P1 and P2 remain separate electrical terminals.
5. That no additional electrical pads were created.

Then STOP.