# Final local OLED short-stock clearance repair

Task: repair ONLY the independent review's195mm OLED cable/left-support clearance defect; retain all positive prior findings and physical qualification gates.

## Change
Reshaped only the195mm OLED stock-case centerline. Maximum change0.942893mm; both PH/SH endpoints unchanged within8e-15mm and guide center unchanged within9.2e-11mm. No support material removed: existing wall/web thickness, fasteners, mounting datums and assumed20N load path remain unchanged. No additional load/strength claim.

Installed OLED cable reservation v3 uses new source family with LENGTH_MM=200 by default. Thus the selected nominal200mm installed geometry remains unchanged; the corrected195mm case is reproducible by setting LENGTH_MM=195. The205mm case is also retained. This avoids showing a195mm wire as though it were nominal200mm stock. Encoder cable, guide, all other parent parts, child data, copper and BOM counts unchanged.

## Exact local checks
|Stock case mm|Integrated length mm|Minimum radius mm|Exact cable/support gap mm|Exact cable/guide gap mm|
|---|---:|---:|---:|---:|
|195|194.998294|15.298166|1.198464|1.218700|
|200|199.998286|15.494188|1.011228|1.308643|
|205|204.998080|15.199198|1.238573|1.315262|

All three exact swept solids valid, with zero common volume for the tested support/guide pairs. Exact segment narrowphase, not the former mesh clearance bound. Length integration residuals are under0.002mm; no stock-length assertion beyond the sourced195–205mm drawing range.

Independent review's original195mm exact gap0.371317mm was below assumed0.5mm by0.128683mm. New exact gap1.198464mm exceeds the requested1.0mm target by0.198464mm and leaves0.698464mm after the same assumed0.5mm allowance. The old0.05368mm figure was a conservative mesh lower bound, not the original exact clearance; it is superseded.

Local regression against previously identified neighboring geometry: conservative lower gaps are carrier0.504535mm (excluding intended plug attachment endpoints), U1 5.065560mm, left frame3.740978mm, base9.417136mm, chamber5.644246mm. Support lower bound0.897456mm is intentionally conservative and is superseded by exact1.198464mm for this named pair. No new broad review was performed.

Readback confirms new installed asset at unit scale, panel datum relative(0,-57.5,61.5)mm/Rx67.1354918781deg; current render shows unchanged nominal bow with existing guide/support. Three updated selected-assembly exports each contain169 valid solids.

## Sources and replay
Installed parametric family: https://cdn.flux.ai/document_assets/oled-stock-family-final-e81c1887-0794-47d0-bc7e-0cd9187318d5.build123d
Local scene: https://cdn.flux.ai/document_assets/single-tube-rt-lamp-reader-scene-89cf0277499372d3a25f26fd17b57fb5.fluxscene
Replay check_local_fix.py using included source family, support, guide and records.json. local_regression.py checks only the cached prior neighbors. local_short_fix.py records the bounded local optimization. Historical195mm controls are included for comparison, not installation.

No renewed part/knob or connector relocation decision. Prior positive review findings retained. Actual cable OD/bend/fatigue, exact connector keyed seating, guide material/fit, encoder housing/load, knob engagement and electrical/voltage checks remain physical qualification gates. No purchases, routing, manufacturing or heater release. **Heater DO NOT ENERGIZE.**
